MDE883-60 - Elliot Gold™ Series Central Workstation (Long Travel) with rotation, tilt and transverse motion

Elliot Gold™ Central Workstation (Long Travel) with Rotation, Tilt and Transverse Motion   

MDE883-60   

Optical workstation with 2 axes of precision rotation, 1 axis of tilt and 2 axes of linear travel.

• ± 4° adjustment, 1 arc sec resolution for θx and θz
• ± 1° for θy
• 60 mm travel, 0.5 µm resolution for Y axis
• Direct readout of device Y linear travel position.
• 6 mm travel, 2 µm resolution for Z axis
• Mounts directly onto 25 mm or 1" pitch table

The Central Workstation provides roll (θx) and pitch (θy) at a height of 125 mm from the bottom of the base plate and these both coincide with the yaw (θz) axis at a height of 18 mm above the middle of the top plate of the θz rotation unit. Rotation axes are defined by curved bearings hence rotation is always in a true arc. Digital readout of the Y travel is provided to allow the operator to read waveguide positions. Thus stepping the fibre across the substrate to locate individual waveguides becomes a simple task.

Application Note

The MDE883 Central Workstation was designed to be a key part of the MDE881 6-axes manipulator. However for applications where the geometry of the standard MDE881 is not suitable we offer the system in its key component parts, allowing custom set-ups to be configured on an optical table or breadboard. This approach means that the system can be purchased in parts as required.

Thus the MDE883 can be used in situations where the standard in-line configuration of the MDE881 is not suitable. For example when the waveguide inputs and outputs are angled at 90 degrees. Alternatively, building the system in kit form provides greater flexibility in adapting the modules to a wider range of applications.